Configuring Port Security; Figure 3-70. Storm Control Page - Alcatel OS-LS-6224 User Manual

3
Configuring the Switch
• The range for GE ports is 3500 - 1000000.
• The default value is 3500.
• Broadcast Mode — Specifies the Broadcast mode currently enabled on the
device or stack. The possible field values are:
• Broadcast Only — Counts only Broadcast traffic.
• Multicast & Broadcast — Counts Broadcast and Multicast traffic together.
Web – Click Security, Traffic Control, Storm Control, define the fields, and click
Apply.
CLI – The following is an example of the Storm Control CLI commands:
Console# configure
Console(config)# port storm-control include-multicast
Console(config)# interface ethernet 2/e3
Console(config-if)# port storm-control include-multicast
Console(config-if)# port storm-control broadcast enable
Console(config-if)# port storm-control broadcast rate 900

Configuring Port Security

Network security can be increased by limiting access on a specific port only to users
with specific MAC addresses. The MAC addresses can be dynamically learned or
statically configured. Locked port security monitors both received and learned
packets that are received on specific ports. Access to the locked port is limited to
users with specific MAC addresses. These addresses are either manually defined
on the port, or learned on that port up to the point when it is locked. When a packet
is received on a locked port, and the packet source MAC address is not tied to that
148

Figure 3-70. Storm Control Page

4-398
4-380
4-398
4-398
4-399