Ip Igmp Snooping Leave-Time-Out - Alcatel OS-LS-6224 User Manual

Parameters
• time-out — Multicast device timeout in seconds (Range: 1 - 2147483647)
Default Setting
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
There are no user guidelines for this command.
Example
The following example configures the multicast device timeout to 200 seconds.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping mrouter-time-out 200
Related Commands
ip igmp snooping querier enable

ip igmp snooping leave-time-out

The ip igmp snooping leave-time-out Interface Configuration (VLAN) mode
command configures the leave-time-out. If an IGMP report for a multicast group was
not received for a leave-time-out period after an IGMP Leave was received from a
specific port, this port is deleted from the member list of that multicast group. To
return to the default configuration, use the no form of this command.
Syntax
ip igmp snooping leave-time-out {time-out | immediate-leave}
no ip igmp snooping leave-time-out
Parameters
• time-out — Specifies the leave-time-out in seconds for IGMP queries.
(Range: 0-2147483647)
• immediate-leave — Indicates that the port should be immediately removed
from the members list after receiving IGMP Leave.
Default Setting
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
The leave timeout should be set greater than the maximum time that a host is
allowed to respond to an IGMP query.
IGMP Snooping Commands
4
417