Chapter 38 Qos Commands - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Alcatel-Lucent's QoS software provides a way to manipulate flows coming through the switch based on
user-configured policies. The flow manipulation (generally referred to as Quality of Service or QoS) may
be as simple as allowing/denying traffic, or as complicated as remapping 802.1p bits from a Layer 2
network to ToS values in a Layer 3 network.
This chapter provides information about configuring QoS global and port parameters through the
Command Line Interface (CLI). Refer to
commands used to configure QoS policy rules.
MIB information for the QoS commands is as follows:
Filename: alcatelIND1Qos.mib
Module ALCATEL-IND1-QoS-MIB
Important Note. Some of the commands listed here are not currently supported on one or more plat-
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.
The QoS commands are listed here:
Global commands
OmniSwitch CLI Reference Guide
38 QoS Commands
Chapter 39, "QoS Policy Commands,"
qos
qos trust ports
qos default servicing mode
qos forward log
qos log console
qos log lines
qos log level
qos default bridged disposition
qos default multicast disposition
qos stats interval
qos nms priority
qos phones
qos user-port
debug qos
debug qos internal
qos clear log
qos apply
qos revert
qos flush
qos reset
qos stats reset
show qos queue
show qos slice
show qos log
show qos config
show qos statistics
November 2009
for information about
page 38-1