Renault Laguna III Manual page 3012

AIR BAG AND PRETENSIONERS
Airbags and pretensioners: Recycling - Destruction
a Connect:
- the adapter to the destruction tool (Ele. 1287),
- the adapter to the airbag.
a Put the airbag on two wooden blocks.
a The destruction procedure is carried out in a stack of
old tyres.
a Make sure that the airbag deployment will not be
hindered.
a Unwind the full length of the wiring for the tool, in or-
der to distance it as far away as possible from the
pyrotechnic component to be destroyed.
a Connect the two feed wires of the destruction tool
(Ele. 1287) to a battery.
IMPORTANT
To prevent any risk of an accident when destroy-
ing a pyrotechnic component, check that no-one
is in the vicinity.
a Destroy the airbag by pressing the two push buttons
on the tool simultaneously.
II - PYROTECHNIC PRETENSIONERS AND INERTIA
REELS
1 - Destruction of part fitted on the vehicle to be
scrapped:
a Move the vehicle outside the workshop.
a Mark the adapter corresponding to the pyrotechnic
component to be destroyed.
a Connect:
- the destruction tool (Ele. 1287) to the adapter,
- the adapter to the pyrotechnic component.
96834
a Unwind the tool wiring fully, so that you are far
enough away from the vehicle (approximately ten
metres) when the device is triggered.
a Connect the two feed wires of the destruction tool
(Ele. 1287) to a battery.
IMPORTANT
To prevent any risk of an accident when destroy-
ing a pyrotechnic component, check that no-one
is in the vicinity.
a Destroy the pyrotechnic component by pressing the
two push buttons on the tool simultaneously.
2 - Destruction of part removed from the vehicle:
a Proceed in the same way as for an airbag (in a stack
of old tyres).
96835
88C-11
88C