Ipv6 Software Access Control List (Acl) Commands; Introduction - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

26

Introduction

Overview This chapter provides an alphabetical reference for the IPv6 Software Access
Control List (ACL) commands, and contains detailed command information and
command examples about IPv6 software ACLs as applied to Routing and
Multicasting, which are not applied to interfaces.
For information about ACLs, see the
Guide.
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself. For more information on link aggregation see the following
references:
•
•
Note that text in parenthesis in command names indicates usage not keyword
entry. For example, ipv6-access-list (named) indicates named IPv6 ACLs entered
as ipv6-access-list <name> where <name> is a placeholder not a keyword.
Note also that parenthesis surrounding ACL filters indicates the type of ACL filter
not the keyword entry in the CLI. For example, (ipv6 access-list standard IPv6
filter) represents command entry in the format shown in the syntax:
[<sequence-number>] {deny|permit}
{<source-ipv6-address/prefix-length>|any}
NOTE
Sub-modes Many of the ACL commands operate from sub-modes that are specific to particular
ACL types. The following table shows the CLI prompts at which ACL commands are
entered.
613-50157-01 Rev C
Access Control List
(ACL) Commands
the Link Aggregation Feature Overview_and_Configuration
Link Aggregation Commands
: Software ACLs will deny access unless explicitly permitted by an ACL action.
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
IPv6 Software
ACL Feature Overview and Configuration
Guide.
843