Oil Pump And Oil Pan Installation - Winnebago 1987-1989 LeSharo Service Manual

1\
ENGINE OVERHAUL
&
REBUILD
REASSEMBLE CYLINDER BLOCK ASSEMBLY
\.,
I
I
• Install an appropriate size replacement lower
bearing in each connecting rod bearing cap and
lightly lubricate them with engine oil.
CAUTION
Ensure that each lower bearing is correctly
matched with its corresponding upper bearing.
• Install each connecting rod bearing cap on its
original connecting rod.
NOTE: The original connecting rod bearing cap bolts
and nuts cannot be reused. Use replacement
bolts and nuts when installing the connecting
rods.
• Install the connecting rod bearing cap nuts and
tighten with 6.0-6.5 daNm (44-48 Ib.lft.) torque.
Use a beam type torque wrench.
• Tap each connecting rod lightly parallel to the
crankshaft and ensure that there is adequate
clearance.
• Rotate the crankshaft and ensure that the pistons,
connecting rods and the crankshaft function
normally.
OIL PUMP AND OIL PAN INSTALLATION
• Install the oil pump.
1\ •
Check for locator pins.
,
i.
• Tighten the oil pump bolts to 4.0-4.5 daNm(29-37
Ib.lft.)
B3-37