Winnebago 1987-1989 LeSharo Service Manual page 680

PART REPLACEMENT
SCUTTLE PANEL
PREPARATION
Cut a section out of a new panel which is larger than
the section it is to replace.
After grinding the joint smooth, apply a coat of
plastic filler or zinc based paint to the new panel to
prevent rust forming.
REFITTING
Mount and align the new panel so that it overlaps
the section remaining in place.
Sawcut both sections to obtain a but joint.
New section
Old section
Overlapped section
Spotweld the following joints:
-C :
w/s
cowl
-D :
"A" ~
front pi liar
Oxy-acetylene or MIG butt weld:
- both panel sections (A) and pillar (8).
- corner (F) where it joins the pillar.
Apply a coat of body solder to the pillar seam.
B
F\
P1-32