r(
I
EXTERNAL
SEAL REPLACEMENT
SPEEDOMETER
SHAFT SEAL
The speedometer shaft seal is replaced using tool
B.Vi. 90S which comprises:
• a seal extractor (A) fitted with a nut (B).
- a seal fitting
tool (C).
- a thin spacer (D).
- spacer (E) is not used.
B
c
REMOVING
Disconnect the speedometer drive cable from the
gearbox.
A
Fit the extractor tool (A) equipped with nut (B) and
spacer (D).
Screw the tool (A) in by approximately three turns
after it has made contact with the seal so that its
thread (1) penetrates the rubber.
Extract the seal by screwing in the nut (B) while
holding the tool (A).
F8-3
A
B 0