Winnebago 1987-1989 LeSharo Service Manual page 446

REBUILD
FINAL ASSEMBLY
REASSEMBLY:
• Fit the 1st/2nd shift fork (with the flat face of the
fork on the 1st speed side).
• Slide the large locking plunger up to the reverse
shaft and ensure that the shaft is locked.
• Insert the 1st/2nd fork shaft, with the small
locking plunger (72) into the fork and lower it into
the bore in the housing. Pin the fork using tool
B.Vi. 949 with the locking recessesin the fork shaft
opposite the secondary shaft.
NOTE:
1 - The seams in the pins must line up with the shaft
centerline.
2 - These pins must be replaced with new ones each
time they
are
removed.
Shaft Centerline
) 1
1
I
_..I
• Fit the 3rd/4th speed fork (flat face towards 4th
speed) on the sliding gear. Ensure that the reverse
shaft and 1st/2nd fork shaft are locked. Slide the
3rd/4th fork shaft into the fork and lower it into
the housing. Ensure that the bore recesseson the
shaft are opposite the secondary shaft and that
the plunger (74) is in position. (See G3-35) Pin the
fork in place using tool B.Vi. 949.
G3-36
1
I