Winnebago 1987-1989 LeSharo Service Manual page 624

COMPONENTS
The major components of the system are:
• Signal Generator - attached to the speedometer
cable drive adaptor at the transmission.
• Regulator - a
computer
board mounted behind the
instrument panel.
• Servo - mounted in the engine
compartment
and
linked to the throttle.
• Control Switch - on the steering column near the
turn signal lever.
• Disengagement Switch/Dump Valve Assembly -
operated by the brake pedal.
All other parts in the kit are for connecting these
components to the vehicle, and to each other.
SIGNAL GENERATOR
CAUTION
Be SURE all square driving
members
and
speedometer
cable are properly engaged with their
mating counterparts and all cable nuts are tight.
"Snap-in" type ends must be completely engaged.
AUXILIARY TRANSMISSION KICK-DOWN SWITCH
Explanation of Auxiliary Switch: When the Cruise
Control is pulling on the throttle, the vehicle's
existing trans. kick-down switch cannot be activated
because the vehicle's throttle cable is at rest. The
switch is activated when cruise cable moves to nearly
full end of its travel. The throttle linkage strikes
switch lever and closes the contacts of switch to
activate kick-down.
A. Bracket and Micro-Switch Assembly. To install,
unscrew
metric
hex head, screw, slip notch of
bracket under lock-washer and retighten screw
to hold switch bracket. (See Figure 7).
NOTE: Switch is factory adjusted, but if kick-down
need be adjusted, the lever of the switch can
be bent to get adjustment. After adjusting,
move throttle by hand to full open to see
that switch IS NOT acting as a stop.
'''0'' Ring
Seal ~
'r""m;,,,," ~~
ca\e7(:
\
'Signal Seal A~ Trans
Generator
14,,>r
\
~/.
~ Speedometer
Speedometer
!~W
Cable. Lower
Cable-Upper
4[:.\ ~\
Split Plastic
\ ~P( ': Retainer Snaps
~• /:;~>
Into Groove .
t.>~c·
Not Included in Kit
/'
.~
.-y \
,~
/::=---V /
'These Parts Furnished Assembled
/\ '--.~ __ J'----"
/ Wire Tie
Existing
Mounting
Screw
J
1,
J
01-2