REBUILD
SECONDARY
SHAFT ASSEMBLY
--)
'-I
REASSEMBL
Y:
Install or Connect:
• The circlip (33).
• The step down
gear (37), ensuring that
the
shoulder (A) is on the correct side.
• The washer (35) with the large flat face on the
step down gear side. The shouldered face goes
toward the bearing (34).
• The bearing (and the spring washer, in those cases
where one is fitted).
• The circlip (33) using tool B.Vi. 902-01 if necessary.
• Ensure that the circlip is correctly located in its
groove in the secondary shaft.
• Refit the gear wheels by performing the removal
sequence in reverse and oiling the gear wheels
and synchornizer rings.
• Fit the synchronizer springs to the 1st and 2nd
gear wheels with their
ends folded
into the
apertures in the gears.
G3-29