Winnebago 1987-1989 LeSharo Service Manual page 458

SPEEDOMETER SHAFT SEAL
REMOVE AND REPLACE
The speedometer shaft seal is replaced using tool
B.Vi. 90S which includes:
a seal extractor (A) fitted with a nut (8),
a seal fitting tool (C),
- a thin spacer (D),
- spacer (E) is not used.
REMOVING
• Disconnect the speedometer drive cable from the
gearbox.
• Attach the extractor tool (A) equipped with nut
(B) and spacer (D).
• Screw the tool (A) in by approximately three turns
after it has made contact with the seal so that its
thread (1) penetrates the rubber.
• Extract the seal by screwing in the nut (B) while
holding the tool (A).
c
; •
I
lJ
REFITTING
c
B. Vi. 905.02 •
• Placethe seal on tool (C) as shown and hit the end
of the tool.
G4-2