Winnebago 1987-1989 LeSharo Service Manual page 660

WINDSHIELD
7. Spray a mist of water onto urethane and dry off
areas where molding will contact body and
glass. Urethane is a moisture curing compound,
so this step will assist the curing process.
IMPORTANT
Reveal moldings must be installed into urethane
adhesive within 10 minutes after application.
8. Slide molding caps onto both ends of one of the
reveal moldings and peel backing from butyl
strips on rear edges of moldings. If original
moldings are reusable, remove any excessive
butyl or urethane from rear edges.
9. Install reveal moldings by pressing retention lip
into urethane using glass edge as a guide. (See
cross section, Fig. F).
IMPORTANT
Make sure molding is seated at corners and that
butyl tape contacts body and glass as shown. (Fig. F).
Use hand roller if necessary to obtain best fit to body
and glass. Use duct tape to hold molding down in
correct position until adhesive cures.
WARNING
Vehicles should be allowed to remain at room
temperature for six hours before being driven to
allow proper curing of adhesive.
CLEAN-UP
A solvent such as naptha is suggested for cleaning
tools and equipment. For hand cleaning, use a
lanolin base, waterless hand cleaner.
P1-12
Butyl Tape
CD
1
J