REBUILD
PRIMARY SHAFT ASSEMBLY
'-.-.1
I
The clutch shaft is removed and the pentagonal
circlip fitted in the sleeve using tools Emb. 880 and
part
"B"
of tool Emb. 1075.
REMOVAL
Fit part
liB"
of Tool Emb. 1075, which matches the
shaft diameter, and tighten
it on the splines.
Screw tool Emb. 880 onto this tool and remove the
shaft.
"-I
i
,
The pentagonal circlip with a square cross-section
must be replaced with
a new one after
each
dismantling operation.
Using a small screwdriver and pliers, take the circlip
out of the sleeve.
Refitting
Fit the pentagonal circlip in the sleeve using tool
Emb. 1075.
G3-25
Emb. 1075