COMPONENTS
TORQUE CONVERTER
1
REMOVAL
When the converter has been removed, remove the
seal using a chisel or a seal extracting tool.
Checkthe condition of the smooth part of the stator
shaft (1).
A torque converter seal retainer (used in ML1-011
automatic
transmissions)
may be retrofitted
to
model ML1-010 transmissions as described below.
INSTALLATION
1. Remove and discard the two existing bolts at
bosses 1 and 2.
2. Install retainer over seal as shown using new,
longer bolts.
3. Coat new retainer bolts with silicone sealant
before inserting.
4. Torque tighten retainer bolts to 2.5 daNm (18
Ib.lft.)
REASSEMBLY
• Lubricate the seal and push it on using tool B.Vi.
465 .
• Refit the converter
after lubricating
the joint
face.
Bolts
F3-16