ENGINE OVERHAUL
AND REBUILD
PISTON SLEEVE ASSEMBLIES
REMOVE OR DISCONNECT
• Sleeves from piston - connecting
rod assemblies
• Rings from pistons.
IMPORTANT
The piston pins are pressed into the connecting
rods and rotate freely in the piston bores. To
remove and install the piston pins, use Piston Pin
Removal and Installation
Tool Set Mot. 574-07.
Tool 574-07 Consists of:
•
Support block (A)
•
Extraction Mandrel (B)
•
Guides (C)
•
Insertion Mandrels
(0)
The block has two (2) grooves (T) for the purpose of
alignment.
Presseach piston pin out of each connecting rod with
the extraction
mandrel (B).
NOTE: The support block (A) and extraction mandrel
(B) are part of the tool set 574-07.
I
I
i
I
r-
I
;
r
r
I
r~
\
I'
I
\
I
.
\
l-
I
A
B3-20
,I
\