FINAL DRIVE REBUILD
REASSEMBLY
-I
l
, 1
i
I
\
,
1
IMPORTANT
All the separator housing bolts must be coated with
anaerobic sealer before being installed.
INSTALL:
- washer (28),
- circlip (1) (bringing it under groove (G) to output
shaft (8).
Usetool B.Vi. 959 to position circlip (1) in its groove:
- fit washer (D) from the tool on the circlip,
place crescent piece (E) in the tooling groove (G)
and tighten the three bolts (V) until circlip (1)
enters its groove.
Make sure that (1) is positioned correctly.
Refit:
- circlip (9) using tool B.Vi. 902-01 (keep the output
shaft in position through the inspection
cover);
- center housing (26) equipped with its seal (cap
towards the bottom) and its magnet (F).
See Subsection 6 for assembling the gear section
casing to the separator casing.
u=m
F7-23