DRIVE SHAFTS
OVERHAULING (LOBRO 6-BALL COUPLING)
Two operations may be carried out on this type of
coupling:
- a coupling change
- a boot change
6·BALL COUPLING AT THE WHEEL END
1. Bell-shaped stub axle
2.
Drive shaft
3.
Rubber boot
4. Balls
5. Ball hub
6. Ball cage
7. Retaining ring
DISMANTLING
- Cut the clip and boot all the way along.
- Remove as much grease as possible.
- Spread retaining ring (7) and tap the exposed face
of ball hub (5) at the same time.
- Separate the coupling from the shaft.
J8-8
7
3
-,
I
5
J
)
1
J
.1
,
~j
I
J
--)
I
j