STUB AXLE CARRIERS
CHANGING
THE BEARINGS
• Insert circlip (5) so that it rests against the outer
race. Make certain that it is fully seated in the
groove.
• Coat each lip seal with grease.
• SliP thrust washer (1) on the hub and press in the
hub-disc assembly using a piece of tube 53 mm
(2.08") OD x 43 mm (1.70") ID, applying the load
to the inner race.
STUB AXLE
CARRIER
REMOVAL
& REASSEMBLY
The bearing replacement steps described above must
be performed first in order to gain access to the
carrier assembly.
NOTE: The bearing assembly is non-serviceable and
must be replaced whenever it is removed.
J4-4
5