ENGINE OVERHAUL
&
REBUILD
REASSEMBLE
CYLINDER
BLOCK ASSEMBLY
I"
I
,
Ensure that:
• the number one liner assembly is installed at the
flex plate end of the cylinder block.
The #1 liner
assembly
was determined
by
protrusion measurements shown on page 83·26.
• A number is stamped on each connecting rod
toward the intermediate shaft side of the cylinder
block.
• the lubrication hole (B) in each connecting rod is
adjacent to the oil filter side of the cylinder block
on oil galley side.
• the arrow stamped on each piston points toward
the flywheel/drive plate end of the cylinder block.
• Install cylinder liner clamps Mot. 588 and spacers
Mot. 588.99.
r-
I
\
[
[
L
I