Winnebago 1987-1989 LeSharo Service Manual page 279

DIAGNOSTICS
FAULT . CORRECTION CHART
GRABS WHEN CHANGING GEAR
FAULT - PROBABLE CAUSE
1. Engine not tuned properly.
2. Lack of fluid in gear section
CHECKS - CORRECTIVE ACTION
Tune the engine
Check the fl uid level. Check for leaks.
3. Vacuum capsule hose kinked or capsule Check condition and routing of hose and capsule
damaged
, I
i
'I
(
4. Incorrect fluid pressure
5. Incorrect assembly or operation of hydraulic
control unit.
Check fluid pressure and adjust (F2-34)
Check that the hydraulic control unit is tightened
properly
- Check position and condition of its seal
- Check hydraulic distributor (see "Hydraulic
Control Unit" Subsection)
\
1
CREEP IN "N"
FAU LT - PROBABLE CAUSE CHECKS - CORRECTIVE ACTION
1. Fluid appearance - Check appearance of the fluid (if it is dirty and
smells burnt, see point 3)
2. Adjustment of gear selector lever incorrect. - Adjust selector lever
3. E1-E2 clutch damaged Change damaged components
Excessive cree pin "0"
_____ F_A_U_L_T_-_P_R_O_B_A_B_LE_CA_U_SE
I
CHECKS - CORRECTIVE ACTION
1. Engine idling speed not adjusted. Adjust engine idling speed.
2. Damaged converter (metallic noise) Change the converter
F2-5