REBUILD
SECONDARY
SHAFT ASSEMBLY
1
st
TYPE OF ASSEMBLY
The 45° inlet chamfer "E" for the recess under the
synchro cone can only be fitted with a "Z-shaped"
spring.
45·
Remember: Make sure the synchro roller "Z-shaped"
springs are mounted the correct direction : locking
the tabs fitted at the lock ring end.
\ I
n
I
J
I
20·
2nd TYPE OF ASSEMBLY
Special Point: idler gears with a 20° inlet chamfer
"E" can be fitted
either with
"heart-shaped"
or
"Z-shaped"
springs.
However,
different
shaped
springs must not be used on the same synchro
assembly.
Make sure the "heart-shaped"
springs are fitted
correctly with the flat section fitted at the synchro
hub end.
G3-34
\
i
. .1