Winnebago 1987-1989 LeSharo Service Manual page 51

I
l. :
ENGINE REMOVE AND REPLACE
FINAL PROCEDURES AFTER INSTALLATION
IMPORTANT
• All rubber shrouds and shields must be in place.
• Use correct motor oil (See specifications section
of vehicle operators manual)
• Use correct type and mixture of antifreeze.
• Make sure cooling system is properly bled of air
and filled to proper level (See Cooling System,
Section E)
CAUTION
It is extremely important to make sure the
cooling system has all the air bled out of it and
contains the proper level of coolant. Serious
engine damage due to overheating will occur if
this it not properly done.
• Pressure check cooling system for leaks (See
Cooling System, Section E).
• All wiring and grounds must be properly
connected.
• Check headlight alignment.
• Air conditioning should be properly charged
and working correctly (See Air Conditioning,
Section N.)
• Make sure that all reinstalled body parts and
bumper fit correctly and hood latch pin
properly aligns with the fender connecting
crossmember. Adjust hood latch pin if
necessary.
When the engine is reinstalled in the vehicle:
• Adjust all controls.
• Perform all functional checks as prescribed in
section CS to determine that all systems are
adjusted and operating properly.
• Reset intergrator voltage adjustment at air flow
meter and reinstall a new tamper-proof plug.
B2-9