Sending Unit Removal; Sending Unit Installation; Sending Unit Testing - Winnebago 1987-1989 LeSharo Service Manual

FUE L TANK GAUGE SENDING UNIT
REMOVE AND REPLACE
SENDING UNIT REMOVAL
• Remove retaining screws
• Pull sender up and out being careful not to bend
or alter any of its components.
SENDING UNIT INSTALLATION
• Install new gasket on tank.
NOTE: Fuel sender mounting screw ho-Iesand gasket
have an un-even pattern a
ncl
can only be
installed one way. This is
to
insure that the
sender is always mounted correctly. Make
sure the gasket holes align with the sender
mount holes.
• Install sender being careful not
"to
bend or alter
any of its components.
• Install 4 of the 5 mounting screws· the fifth is for
the ground wire when reinstalling the tank
assembly in the vehicle.
SENDING UNIT TESTING
• Refer to Section D - Electri
<a
I
for testing
information (See pg. D2-1).
C8-2
(
I
,
t