Winnebago 1987-1989 LeSharo Service Manual page 418

5-SPEED GEARBOX
GEAR DISASSEMBLY/REASSEMBLY
- Reattach the following parts to the secondary
shaft:
- Circlip (33)
Step-down gear (37) - Be sure that the shoulder
(A) is on the correct side.
Washer (35) - The large bearing surface should
face the step-down gear.
Bearing (and spring washer, if equipped).
Circlip (33) - Use tool #B.Vi. 902-01 if necessary.
- Be sure the circlip is correctly located in its groove
in the secondary shaft.
- Reassemble the gears in reverse order of removal.
Oil each gear and synchronizer ring as you
reassemble them.
- Fit the synchronizer springs to the 1st and 2nd
gears with their ends folded into the cutouts in
the gears.
- Be sure the synchronizer gear assemblies are
facing the right direction.
The beveled side of the teeth on the 1st/2nd
synchronizer gear should face 2nd gear.
1st
2nd
84439
. I
)
·'···.·1
:
I
J
G3-8