TRANSMISSION REBUILD
CLEAN AND INSPECT
MARK THE FACEOF THE PUMP OUTER PINION and
remove (2).
CLEANING
Do not use trichloroethylene
as this may splash on
the seals and cause damage.
Do not use shop towels which could leave lint
particles in the system.
Use:
- solvent or degreasing fluid, (except on the seals)
and lint-free towels for wiping off.
compressed air, blowing hard in all holes, feed
ways and oitways on:
the gear section causing (1)
the free wheel (17)
the forward gear train (11)
the reverse gear train (16)
the E2 clutch housing (14)
pistons (12-3)
feed hub (5)
pump (2)
pump shaft (38)
turbine shaft (39)
Mark
F5-9
2
J