Winnebago 1987-1989 LeSharo Service Manual page 638

COMPONENTS
SHOULD IT BECOMENECESSARY TO REPLACE SPEEDCONTROLCABLE,USETHIS PROCEDURE
1/4-20 Nut
&
Lock
Washer Assembly
A.
B.
c.
Green Grounding Wire
in Servo Harness
PIN
53A-00172
Small Plastic Cover
PIN 55A-00804
Cable Coupling
Cable Core
Rubber Sleeve
I I
To remove old cable, slide rubber sleeve off D.
cable end fitting so slots are exposed.
Slide small plastic cover off coupling and onto
servo coupling cable. Use side cutter pliers or E.
small screwdriver to spread coupling. Remove
core end of old cable from coupling.
Remove and retain two NO.6 screw and washer F.
assemblies-attaching cable end fitting to servo.
02-4
Existing No.6 Screws
Thread servo coupling cable into end fitting of
new Speed Control cable and out through slot.
Attach cable to servo with two screws retained.
Put core end of cable in coupling and squeeze it
closed with pliers. Slide small plastic sleeve back
onto coupling.
From other end of cable, pull all slack from
cable core and slide rubber sleeve back into
place over end fitting slots.
1
I
1
I
j