Table of Contents
Advertisement
COMPONENTS
1/4-20
Nut
&
Lock
Washer Assembly
Green Grounding Wire
in Servo Harness
PIN
53A-00172
Small Plastic Cover
PIN 55A-00804
Cable Coupling
Cable Core
I I
Existing No, 6 Screws
Speed Control Cable
End Filling
Rubber Sleeve
c
1
i
J
,I
\
i
j
\
I
A.
To remove old cable, slide rubber sleeve off
cable end fitting
so slots are exposed.
B.
Slide small plastic cover off coupling and onto
servo coupling cable. Use side cutter pliers or
small screwdriver to spread coupling. Remove
core end of old cable from coupling.
C.
Remove and retain two
No. 6 screw and
washer assemblies-attaching cable end fitting
to servo.
D. Thread servo coupling cable into end fitting
of
new Speed Control cable and out through slot.
Attach cable to servo with two screw retained.
E.
Put core end of cable in coupling and squeeze
it closed with pliers. Slide small plastic sleeve
back onto coupling.
F.
From other end of cable, pull all slack from
cable core and slide rubber sleeve back into
place over end fitting
slots.
01-4
Advertisement
Table of Contents
Troubleshooting
