DRIVE SHAFTS
OVERHAULING (SPIDER G182 COUPLING)
I
I
LI
REASSEMBLING
VVhen changing a yoke:
- Lubricate the drive shaft and slide on the new
retaining clip and boot.
- Slide the yoke cover over the shaft and spider gear
onto the drive shaft splines.
Crimp at 3 points
1200
apart by peening the spline
metal over onto the drive shaft.
• Align the 2 raised dots on the cover with a yoke
cut-out (the yoke bei ng fitted with a new O-ri ng
(3) and slide the yoke into the cover.
• Use a press to crimp the cover over the yoke.
• Make sure the yoke is fully seated.
DO NOT ALLOVV THE PRESSURE TO INCREASE.
• Crimp the cover to the yoke in this position then
complete the operation in the same manner as for
a boot change.
J8-7