j
COUPLING TRANSMISSION TO FINAL DRIVE
ADJUSTING THE END FLOAT
The end float is the operating clearance of the gear
section of the automatic transmission.
THE AVERAGE CLEARANCE
(J)
MUST BE 0.8 mm. The
end float is adjusted by shim (K) which is a ground
shim.
K
J
0.8 mm (0.65 - 1.0 mm)
End float
(J)
is 0.65 mm to 1.0 mm. It is adjusted by
thickness of shim (K).
IMPORTANT
The end float
must be adjusted
when a service
exchange transmission section is installed as well as
during a transmission or final drive rebuild.
F6-1