Instrument Cluster; Layout; Instrument Panel - Winnebago 1987-1989 LeSharo Service Manual

INSTRUMENT CLUSTER
LAYOUT
INSTRUMENT PANEL
1. Coolant Temperature Warning - If this light
comes on or you have other reasons to suspect
that the engine is overheating, pull the vehicle
over to the side of the road and shut the engine
off immediately. Contact your dealer for
assistance.
WARNING'
Operating the vehicle under an engine
overheating condition for even a short period
of time can result in a risk of personal injury
and serious vehicle damage.
2. Seat Belt Reminder - Lights comes on and tone
sounds for 4-8 seconds after ignition is switched
on as a reminder to fasten safety belts.
3. High Beam Indicator - Illuminated while
headlight high beams are in use.
4. Speedometer
5. Brake Warning - Lights while handbrake is
applied to any degree. Also lights if brake fluid
level is low or if a brake circuit malfunction
exists. If the light is on, be sure that the
handbrake is fully released. If the light remains
lit, stop the engine and check the brake fluid
level. If the brake fluid level is normal, do not
operate the vehicle until you have consulted
your dealer.
6. Oil Pressure Warning - Illuminates when the
ignition is switched on. It should go out as
engine starts. If the light comes on while
driving, stop the engine immediately and check
oil. If the oil level is normal, a malfunction exists
and your dealer should be consulted.
7. Turn Indicator Lights - Both arrows flash in
unison while signaling either direction and
during use of hazard flashers.
8. Brake PadWear Indicator - Light comes on when
either of the front brake pads is worn to a
predetermined level as a warning that brake
service is needed.
9. Battery Charge Indicator - Light should go out as
soon as the engine starts. If it illuminates while
driving, stop the engine immediately and check
drive belts. Tighten or replace as necessary. If
drive belts are satisfactory, a malfunction of the
charging system may exist.
10. Hazard Warni ng Indicator - Flashes whi Ie the
hazard warning flashers are engaged.
11. Automatic Transmission Monitor • Lights up
when the key is switched to the ON position to
verify that all systems are functioning properly.
The light should go out as soon as the engine is
started. If the light comes on while driving, pull
over to a level area on the side of the road, set
the hand brake and check the transmission fluid
level with the engine idling in Park. Add fluid if
necessary. If fluid level is normal, contact your
dealer for assistance.
12. Tachometer - Measures engine speed in
revolutions per minute (rpm).
*
0 - 5500 rpm: normal operating range
*
5500 - 6000 rpm (red lined zone): power
reserve for extremely short periods only
*
6000 rpm or higher (solid red zone): engine
rpm must be kept below this range or severe
damage may result.
WARNING
Be sure to shut off the engine before attempting
to check belts.
13. Panel Lighting Dimmer Knob - Controls the
intensity of the instrument panel lighting.
!
(
1
j
I
•
)
']
J
1
U
n
L
1
t.J
-,
J
1
D3-1