COUPLING TRANSMISSION TO FINAL DRIVE
ADJUSTING THE END FLOAT
The adjustment is made in 2 stages.
1. Final drive end (shim K removed).
- Place tool B.Vi. 715 (or an accurate straight edge)
across the final drive case joint surface as shown.
- Find dimension
E,
which is the distance from the
top edge of the step-down shaft spacer to the case
joint surface.
Zero the dial indicator on the case surface, then
move the indicator to the step-down shaft spacer.
Record this dimension.
y80Vi0715
F6-2
'-j
I
1
I
U
J