COMPONENTS
MULTI-PURPOSE
SWITCH - REPLACEMENT
- Strip the wires back 5 mm (.20 in)
- Place a seal
(J)
on each wire,
- crimp the end terminals in place.
5
I.
When fitting the wires into the connector, ensure
that the color codes are correctly aligned.
Fold down the locking tab on the connector.
There are computers in service which are connected
to the multi-purpose switch via seven wires. In this
case, the white wire sheath is to be cut off flush
with the cable at the computer end.
Check that O-ring (T) is in place and attach the
multi-purpose switch to the automatic transmission.
IMPORTANT
REMEMBERTO RECONNECT THE GROUND LEAD TO
THE AUTOMATIC TRANSMISSIONCASE.
F3-6
/J==fYrm