MASTER CYLINDER
REMOVE AND REPLACE
REMOVAL
• Drain the brake fluid reservoir with a syringe and
remove the rubber rings
• Unscrew:
- the metal pipe unions on the master cylinder
- and the 2 servo nuts
• Remove the master cylinder
REI NSTALLA TION
• Check the master cylinder operating clearance. It
should be 0.5 mm (.020") measured from the end
of the pushrod to the master cylinder mounting
face (dimension X). Turn pushrod nut (P) to adjust
if necessary.
• Attach the master cylinder to the brake servo
• Reconnect the brake lines to the correct unions on
the master cylinder.
• Reassemble the
fluid
reservoir
including
the
rubber rjngs
• Fill the reservoir
• Bleed the system
12-1
,jI[11
0\