STUB AXLE CARRIERS
CHANGING
THE BEARINGS
REMOVE:
• The Torx® head bolts from the lower ball joint
mount.
• The shock absorber bottom bolts (4).
• The circlip from the hub.
• The outer race using a press and one of the old
inner races, leaving the ball cages and seals in
position.
REASSEMBLY
• Remove the two plastic covers (A) from the oil
seals on the new bearing.
• Press in the complete new bearing with its plastic
ring. Hold the 2 inner races using a piece of tube
83 mm (3.26")
00
x 76 mm (3.00") ID. Apply
pressure to the outer race only.
• Do not press on the inner race since this could
damage the bearing.
J4·3
\
(
I