Rebuild Final Assembly - Winnebago 1987-1989 LeSharo Service Manual

REBUILD
FINAL ASSEMBLY
1
J
Reassembly:
• Place the locking balls in the housing :
• Between the reverse shaft and 1st/2nd shaft bores
(73).
• Between the 1st/2nd and 3rd/4th shaft bores (74).
• Ensure that they slide correctly.
• Refit the shafts to the step down housing.
• Precautions: To avoid damaging the lip on the
primary shaft seal, carefully guide the clutch shaft
to prevent its splines or sleeve from making
contact with the Ii p on the seal.
1st arrangement:
• The clutch shaft is integral with the primary shaft.
2nd arrangement:
• A coupling flange (M) is press fitted to the clutch
shaft (25) and is clipped to the primary shaft (26).
• The two shafts are assembled after fitting the
primary shaft to avoid damaging the lip seal (E).
See page G3·26;
• Fit the speedometer worm to the secondary shaft.
• Connect the primary shaft to the secondary shaft.
Take both the shafts and position them in their
housings simultaneously.
• Fit the reverse shaft with locking recessesopposite
the shafts.
• Turn the speedometer pinion and tap the three
shafts with a plastic mallet until they align into
their correct positions.
• Place a cloth under the step down gears to prevent
any parts from falling into the housing.
G3-35
~.!!
\ '
!
I
I