STUB AXLE CARRIERS
CHANGING
THE BEARINGS
REMOVING
Place the vehicle on stands.
• Remove the wheel.
• Remove the brake caliper without
disconnecting
the hose.
• Mount locking tool Rou. 604 to prevent the hub
from turning
and unscrew the drive shaft nut.
Rou.604
T.Av.601
l
• Mount extractor T.Av. 601 using the 4 wheel nuts.
• Remove the long bolt from the extractor, mount
slide hammer Ms 580 in its place and extract the
hub-disc assembly.
• Use an axle bearing splitter/extractor
as shown to
remove the inner race thrust washer remaining on
the hub. Obtain tool from local tool vendor. Jaw
range 0-100 mm (4").
• Retain the thrust washer.
• Extract the steering arm ball joint from the stub
axle carrier using extractor T.Av. 476
J4-2
•••
Ms. 580
u~~_J
T.Av.476