ENGINE OVERHAUL & REBUILD
REASSEMBLE CYLINDER BLOCK ASSEMBLY
r
I ..:
r
I
l "
! ;
I.~
l~
I
\
...
I
\
~
With
all the
cylinder
liner
protrusions
within
tolerance, arrange them so that:
• the difference in protrusion between any two (2)
adjacent liners does not exceed 0.04 mm (0.002 in)
• the protrusions
are stepped
down
from the
number one (1) cylinder to the number four (4)
cylinder or from the number four (4) cylinder to
the number one (1) cylinder.
• when the correct protrusion
arrangement
has
been decided, match each piston and connecting
rod assembly with its original liner and re-mark
each according to the new position.
Install the piston and connecting rod assemblies in
their
matched set liners with
piston installation
sleeve, Mot. 851.
83-27
t
E
B-
o