TRANSMISSION REBUILD
CLEAN AND INSPECT
FEED HUB·
SEALING RINGS (5)
Before removing
the rings from the hub check that
they rotate freely on the hub. If any rings are stuck
CHANGE THE HUB-RING ASSEMBLY.
Remove the rings and check the condition
of the
following
on the hub:
the bottom
of the three
grooves in which
the
rings fit,
- the white
metal faced bushing,
- the face at the pump end.
On the rings check:
the ring gap ends (3) - they should fit together
exactly (4).
- the clearance at section (J) : it should be between
0.05 and 0.35 mm (.002 - .010 in)
BRAKES
(7) (13)
Any
lined
discs showing
signs
of
overheating
(blackening
of lining), on which the finish is poor or
which
are worn
must be replaced.
~
,
,I
=i0i
4
Scrap all steel discs that show signs of picking-up
or
seizing.
CLUTCHES E1, E2 (10)
Clutches E1 and E2 cannot
be disassembled.
Clutch 2 has visible discs.
Check the clearance
of clutch
E2 using
a set of
shims.
Maximum
permissible
clearance:
4.1 mm (.16 in)
If clearance
is not correct
replace E1-E2.
F5-12