COMPONENTS
SPEED SENSOR·
REPLACEMENT
This operation
consists of cutting
off the wire
connecting
the electronic
module to the speed
sensor and replacing the sensor with a new one.
Check the speed sensor before cutting the wire.
Contents of replacement sensor kit:
- 1 speed sensor equipped with a wire and a male
connector,
- 1 female connector,
- 2 male pins,
- 2 seals.
Procedure:
Remove the automatic transmission speed sensor
and cut off the cable to the same length asthe cable
on the replacement unit.
At the electronic module end
- remove the protective sleeve and the shielding
back 40 mm (1.5 in)
"
I
I
'i
iI"
I
- strip the two wires back 5 mm (.20 in)
- place a seal on each of the wires,
- crimp the terminals in place.
When fitting the wires to the connector, follow the
wiring
code by placing
the same code colors
opposite one another.
,
I
I
J
[]=={~
Fold down the locking tab on the connectors.
Check that O-ring (T) is in place before reassembly.
F3-7
T
i
,