Winnebago 1987-1989 LeSharo Service Manual page 558

HEAVY DUTY REAR AXLE
CHANGING THE BEARINGS
REASSEMBLY
• If the old deflector has been removed, install a
new one using a piece of pipe with 68.5 mm
(2.69") bore.
• Mount the bearing to the stub axle and push it on
the first 10 mm (.39") using a piece of 36 mm bore
pipe.
• Complete the operation by drawing it on with
sleeve (2) from tool Rou. 898 and the stub axle
nut.
• Fit the following to the hub:
- The bearing outer race using pipe of suitable
diameter
- A new grease seal using tool Rou. 896
- Fill the inside of the hub with 65 g. (2.5 oz) of
multi-purchase grease and smear the rollers and
grease seal lip as well.
• Fit the following to the stub axle:
the hub
the outer bearing
- and the thrust washer and nut
Rou.896
','
.
:.
"'",;:,
"':
.•. , , •r .•..•.
,-
. r
,'.
'
..
•,.::e.: "". ~
~. , .•."'",t •
•• : II' ~ ••••• .,
,
..
"',
.
.•.
'"
."
....•• 7 '''':'''
.
'.
I
J
- Torque tighten the stub axle nut to 10 daNm (74
Ib./ft.) turning the hub-drum at the same time.
- Loosen the nut 72° (the angle between 2
adjacent studs).
Mount dial indicator bracket Rou. 541 and dial
indicator to the drum face and set the plunger
on the end of the stub axle.
- Check the endplay, which should be between
0.02
and
0.08
mm
(.001
and
.003").
Adjust by
turning the nut.
- Fit the nut lock, cotter pin and grease cup filled
with multi-purpose grease. Rou.541
- Adjust the handbrake.
- Fit the wheel and torque tighten the nuts.
K2-3
72046E-BO-OOO