1
I
')
:1
\
'I
)
J
STARTER
REMOVE
AND
REPLACE
NOTE: The starter is removed from below.
REMOVAL
• Disconnect the negative battery cable.
• Disconnect the intake manifold support brackets
(1) at the base plate (2) and remove the base plate
from the engine block (gas engine vehicles only).
• Remove the three starter motor-to-bellhousing
mounting bolts (4).
• Remove the starter mounting bracket bolts (3).
• Lower the starter and disconnect the wire harness
to the starter solenoid.
INSTALLATION
• Connect the wire harness to the starter solenoid.
IMPORTANT
Make sure alignment dowel is mounted in the
starter or bell housing. Mounting
the starter
without
the
dowel
will
result
in starter
drive-to-flywheel
misalignment.
• Position the starter in the bell housing and install
the three mounting bolts (4).
NOTE: Tighten these bolts before proceeding to the
next step.
• Install the starter mounting
bracket attaching
bolts (3).
• Install the base plate (2) on the engine block and
the brackets (1) on the base plate.
• Connect the negative battery cable.
05-1