Winnebago 1987-1989 LeSharo Service Manual page 628

ELECTRICAL CHECK
/
ELECTRICAL CHECK PROCEDURE
se a 12-volt Test Light To Perform These Checks
DITION
POSSIBLE CAUSE
REMEDY
Light OFF, all terminals None. system O.K
lead to each termmal of connector in-
Test light ON at terminals 5.7. and 14 Red tused wire connected to wrong power
source. Use a "switched" power source at
fuse block. Test light should be "ON" when ig- nition sWitch is "ON" and "OFF" when ignition
switch is "OFF".
Test light ON at terminals 5. 7. and 14 None system O.K.
only
dividually.
No light on any terminal
Replace fuse.
if
blown. Connect red wire to ig-
nition switched power source.
Test light OFF at terminal 14. None, system O.K.
hold SET SPEED button and touch other
Test light ON at terminal 14.
See Trouble Shooting GUide - Control
Switch.
Test light ON at terminal 10 and 14. None, system O.K.
hold. Slide switch to RESUME while
No light at terminal 10 and/or 14.
See Trouble Shooting GUide - Control
Switch.
Ignition Switch ON. Control Switch ON.
Test light ON; puSh brake and test light
None. system O.K.
5
goes OFF.
Test light OFF
Adjust disengagement switch. Plunger travel
to get test light ON; OFF when brake pedal is pushed. Ground green servo wIre with eyelet
terminal. Check light green wire connectiony
I
1
A.
A test light or volt-ohmeter is needed to
perform these checks. If you have neither, a test
light can be made as shown.
Solder Two Places
HOMEMADE TEST LIGHT
Leads Approx.
12" Long
12 Volt Bulb
G.E.53
or Equiv.
.\
.\
B. A Speed Control System Tester is available which
will quickly indicate any problem area. The
Dana part number is 250·3122. More
information is given on pages 01-11 and 01-12.
If attaching the connector to the tester, the dark
green wire and Light NO.1 are at the same end.
01-6
Dark Green to Smaller Terminal Numbers
Terminal 14 Are Mounted on This Surface
\-~