Winnebago 1987-1989 LeSharo Service Manual page 45

I·,
U
(
L
ENGINE REMOVE AND REPLACE
REMOVAL PROCEDURE CONTINUED
REMOVE OR DISCONNECT:
Supply hose from power steering reservoir to
pump. Drain fluid into container.
- Pressure hose from rear of power steering
pump
Engine ground strap
Air hoses from air flow meter to plastic elbow
under intake manifold. Cover open elbow to
prevent foreign material from getting into the
engine.
Vacuum hoses for E.G.R. system (behind left
headlight area)
Vacuum hose to brake booster
Vacuum connections on top of intake manifold
for cruise control and charcoal canister
Vacuum hoses at left rear of engine to charcoal
canister and automatic transaxle
Fuel feed and return hoses at frame rail
connections to metal piping. Mark connections
for proper hook-up.
Throttle and cruise cables from engine.
Flywheel cover behind engine oil pan.
All 3 torque converter to flexplate bolts (ATX
only)
Motor mount to transaxle mount on right side -
2 bolts rear of oil pan.
Motor mount to transaxle mount on left side - 1
long bolt and lock nut.
Bolts that hold T.D.C. sensor to flywheel
housing. Set sensor aside.
CAUTION
Failure to remove sensor may cause damage to
the flywheel.
- Bolts that hold transaxle to engine and starter.
B2-3