ENGINE WATER PUMP
REMOVE AND REPLACE
IMPORTANT
The water pump cannot be repaired. Change the
component if any part is worn.
REMOVAL
The timing belt tensioner need not be removed:
• Using a long hose clamps as shown, hold the
timing
belt tensioner
plunger in position
and
prevent spring from flying out.
• Remove the water pump.
Changing the gasket between the water pump and
plate.
• Hold the water pump body in a vise and loosen
the plate.
• Clean the joint faces by moving the plate around
the pump shaft out of the way.
• Select the gasket which fits between the water
pump and cylinder
block. Make the
cut-outs
shown in the illustration
below to allow
the
gasket to slip between the water pump body and
the plate.
NOTE: Special points concerning refitting:
- Clean all joint faces before fitting new dry gaskets.
• Hold the timing belt tensioner plunger in position
as before when refitting
the pump.
INSTALLATION
• Mount the water
pump to the cylinder
block
followed
by the coolant hoes to the pump.
• Fill and bleed the cooling circuit - (See Section E -
Cooling System)
88-1
r
f
I
r
l.
L
[
,
l.
[
[
[
l
[
l
I
L