Starting Drive Mechanism; Adjusting The Starting Drive Mechanism Solenoid Linkage Fork - Winnebago 1987-1989 LeSharo Service Manual

STARTER
PARIS-RHONE D10E88
, I
1
COMPONENT REPLACEMENT
STARTING DRIVE MECHANISM
After removing the armature, tap the stop collar
with a
drift
to disengage the retaining clip.
When installing the starter drive mechanism, put the
clip back in place and push the stop collar over the
clip.
ADJUSTING THE STARTING DRIVE MECHANISM •
SOLENOID LINKAGE FORK
Connect the solenoid to a battery.
With the solenoid energized, measure the clearance
(1) between the drive pinion and the stop.
NOTE: Clearance = 1.5 mm (0.059 in)
If the clearance is not correct, adjust it with an
eccentric pin (2) in the fork.
. I
1 .
.1
(
)
D5-3
2
~"'.'
'C. \
l
,. 'Ij