Winnebago 1987-1989 LeSharo Service Manual page 431

FINAL DRIVE REBUILD
REASSEMBLY
I
Mount the ring gear to the differential housing using
new bolts.
Torque tighten the ring gear bolts. (See G1-4)
Press the ball bearing onto the shaft (34) a few
millimeters at the planetary gear end to center it.
Lift up the assembly to the differential housing
(bearing (34) not being in its working position.)
Coat the half-casing joint faces with anaerobic
sealer, fit the other half-casing and assemble them
with several bolts.
Hand tighten these bolts only at this stage.
Mount the differential ring nut (with its seal and its
threads coated with gasket sealer) using castellated
wrench a.Vi. 645.
Tighten the ring nut until it contacts the differential
bearing outer track ring.
Complete the assembling of ball bearing (34) driving
it on until it touches shoulder (E) in the casing.
Unscrew the differential ring nut one half-turn.
Torque tighten the casing bolts. (See G1-4)
Place the following at the planetary gear end:
- circlip
- plastic bushing
G3-21
B,Vi. 645