Adjusting The Reverse Gear Train - Winnebago 1987-1989 LeSharo Service Manual

TRANSMISSION REBUILD
REASSEMBLY
ADJUSTING THE REVERSE GEAR TRAIN
The object of the adjustment is to restrict the
displacement of the reverse gear train by
determining the thickness of plastic shim (19).
THE AVERAGE CLEARANCE MUST BE 0.4
mm.
The adjustment is made in two stages:
1. At gear selection end
Check that thrust bearing (18) is on the sunwheel
and that there is no plastic shim (19).
- Place tool B.Vi 715 (or an accurate straight edge)
across the case joint surface as shown.
- Attach a dial indicator to the tool or straight
edge and "zero" the indicator on dimension A,
the top surface of the planet gear assembly.
- Next, measure dimension 8, which is the top
surface of the thrust bearing. Record this·
dimension. You will need to subtract it from the
park ring dimension.
1
J
B.Vi.715
B
A
1
j
F5-21
16
"1
J