FINAL DRIVE REBUILD
REASSEMBLY
Press the ball bearing on the shaft (34) a few
millimeters at the planetary gear end to center it.
Lift up the assembly to the differential housing
(bearing (34) not being in its working position.)
Coat the half-casing joint faces with an anaerobic
sealer, fit the other half-casing and assemblethem
with several bolts.
Hand tighten these bolts only at this stage.
Mount the differential ring nut with its sealsand its
threads coated with gasket sealer using castellated
wrench B.Vi. 645.
Tighten the right nut until it contactsthe differential
bearing outer race.
Complete the assemblingof ball bearing (34) driving
it on until it touches shoulder (E) in the casing.
Unscrew the differential ring nut one half-turn.
Torque tighten the casing bolts.
Place the following at the planetary gear end:
the circlip
- and the plastic bushing.
J
\
I
I
I
!
S>
.-
F7-18
E
~