Winnebago 1987-1989 LeSharo Service Manual page 488

REAR BRAKE SHOES
REMOVE AND REPLACE
• Remove brake shoe (1) and disconnect the cable
from lever (2).
• Keep stop plate (3) on its pin duri ng this
operation.
• Remove stop plate (3).
• Disconnect lever (6) from the brake shoe followed
by ratchet arm (4) and its spring (5).
• Check all the components. Replace any part which
appears worn.
• When reassembling : lubricate pin (7) lightly.
• Check the adjuster body and rod assembly. The rod
should screw in freely along the entire length of
the threads.
• When reassembling : lubricate the threads.
• Identifying the L.H. and R.H. adjuster assembly:
L.H. rear brake: this has a R.H. thread and the
ratchet is chamfered.
- R.H. rear brake: this has a L.H. thread and the
ratchet is shouldered.
17-2
~ ~
",'